Page 1 of 1

Request: Reset attributes to default values

Posted: Thu Mar 26, 2020 8:00 pm
by fawkes
Could you please add a possibility to reset attributes to their default values?
When I add motors and then experiment by changing their attributes, often I want to reset a couple of them back to default values.
It would be good if every attribute had a button or a shortcut that would just reset. Otherwise I have to remove the motor entirely, then add it back again and try to remember what were the initial values before I start changing them again.

Thanks

Re: Request: Reset attributes to default values

Posted: Fri Mar 27, 2020 10:04 am
by chong
I will investigate this, will need to see how it works with the rest of the system.

Thanks